联系我们
公司名称：XXX
电话：XXX
手机：XXX
联系人：XXX
地址：XXX
新闻动态
手持式金属探测器
手持式金属探测器（掌型手持式金属探测器,进口金属探测仪搜身手探）用于检查人身携带金属的具体位置，也可配合金属探测门使用，当 “安检门”报警发现金属物品时，用手持式金属探测器即可找到藏有金属物品的准确位置。金属探测器采用长方形检测头，探测区长12公分，检查人体时，从上到下一次性完成检查工作。
Handheld metal detectors (handheld metal detectors, imported metal detectors search hand probe) are used to check the specific position of the metal and can also be used with metal detection doors. When the metal objects are found by the "security door" alarm, the accurate location of the metal objects can be found with a handheld metal detector. . The metal detector adopts rectangular detection head, and the detection area is 12 centimeters long. When examining the human body, the inspection work is completed from top to bottom.
使用之前，首先打开仪器背面的电池盒盖板，装入电池。本仪器使用9V的叠层电池，请注意电池上的标称电压必须是9V，其它的电压绝对不能代用。
Before using, first open the battery box cover on the back of the instrument and load it into the battery. This instrument uses 9V stacked battery. Please note that the nominal voltage on the battery must be 9V, and the other voltage must not be substituted.
本仪器的功耗很低，每一个新装电池可累计工作50小时左右。当电池能量下降到10%时，仪器已经不能正常工作，这时喇叭会发出断续的嗒嗒声，提示我们必须更换新电池。
The power consumption of this instrument is very low, and each newly installed battery can work for about 50 hours. When the battery energy drops to 10%, the instrument is no longer working properly, and the horn will give intermittent click, which means we must replace the new battery.
使用时，安检人员用手握住手柄，用拇指按一下启动按键，然后松开，仪器的信号灯便开始闪烁，喇叭同时发出极轻微的蜂鸣声，表示仪器进入工作状态。工作人员手持开机后的仪器在被检人（或物体）表面来回扫描，如果有金属物体，仪器就会发出声音。检查工作完毕之后，应该按下停机按键，以免浪费电池的电量。
In use, the security inspectors hold the handle with their hands, press the button to start the button with the thumb, and then release, the signal lights of the instrument start to flicker, and the horn sends out very slight buzz at the same time, indicating that the instrument enters the working state. The workers scan the surface of the inspector (or object) with the instrument on hand. If there are metal objects, the instrument will make a sound. After the inspection is finished, the button should be pressed to avoid wasting battery power.
Handheld metal detectors (handheld metal detectors, imported metal detectors search hand probe) are used to check the specific position of the metal and can also be used with metal detection doors. When the metal objects are found by the "security door" alarm, the accurate location of the metal objects can be found with a handheld metal detector. . The metal detector adopts rectangular detection head, and the detection area is 12 centimeters long. When examining the human body, the inspection work is completed from top to bottom.
使用之前，首先打开仪器背面的电池盒盖板，装入电池。本仪器使用9V的叠层电池，请注意电池上的标称电压必须是9V，其它的电压绝对不能代用。
Before using, first open the battery box cover on the back of the instrument and load it into the battery. This instrument uses 9V stacked battery. Please note that the nominal voltage on the battery must be 9V, and the other voltage must not be substituted.
本仪器的功耗很低，每一个新装电池可累计工作50小时左右。当电池能量下降到10%时，仪器已经不能正常工作，这时喇叭会发出断续的嗒嗒声，提示我们必须更换新电池。
The power consumption of this instrument is very low, and each newly installed battery can work for about 50 hours. When the battery energy drops to 10%, the instrument is no longer working properly, and the horn will give intermittent click, which means we must replace the new battery.
使用时，安检人员用手握住手柄，用拇指按一下启动按键，然后松开，仪器的信号灯便开始闪烁，喇叭同时发出极轻微的蜂鸣声，表示仪器进入工作状态。工作人员手持开机后的仪器在被检人（或物体）表面来回扫描，如果有金属物体，仪器就会发出声音。检查工作完毕之后，应该按下停机按键，以免浪费电池的电量。
In use, the security inspectors hold the handle with their hands, press the button to start the button with the thumb, and then release, the signal lights of the instrument start to flicker, and the horn sends out very slight buzz at the same time, indicating that the instrument enters the working state. The workers scan the surface of the inspector (or object) with the instrument on hand. If there are metal objects, the instrument will make a sound. After the inspection is finished, the button should be pressed to avoid wasting battery power.
