保定市探测器厂

现象一：

Phenomenon one:

故障现象：开机1-2秒后报警或震动不停

Fault phenomenon: after 1-2 seconds, the alarm or vibration does not stop

原因分析：一般因灵敏度过高和电力不足会出现这种现象。有的用户在使用一段时间后，没有注意到电池电压已经低于工作电压，往往认为：探测器长鸣不止当作故障返修。

Reason analysis: generally due to excessive sensitivity and lack of electricity will appear this phenomenon. Some users in the use of a period of time, did not notice the battery voltage is lower than the operating voltage, tend to think that more than long as repair fault detector.

排除方法：

Elimination method:

1. 在开机报警时调抵灵敏度，至不报警为止。

1. in the alarm at offset sensitivity, not to alarm so far.

2. 调整不能排除的，更换电池或充电后使用。

2. adjustment can not be ruled out, replace the battery or after charging use.

注：此时调低调低灵敏度不影响探测精度。

Note: low profile and low sensitivity do not affect the detection accuracy.

现象二：

Phenomenon two:

故障现象：带震动的探测器，有时蜂鸣器工作正常，而转到震动时出现震动马达不能停下来。

Malfunction: a vibrating detector, sometimes the buzzer works properly, and vibrates when it goes to vibrate. The motor can't stop.

原因分析： 出现此类现象一般是用户使用一段时间后没有注意到电压在下降。因为马达耗电超过蜂鸣器，此时的电压只能保证蜂鸣器正常工作。

Reason analysis: this phenomenon is usually the user after a period of time did not notice the voltage is declining. Because the power consumption of the motor exceeds the buzzer, the voltage can only ensure the buzzer work properly.

排除方法：

Elimination method:

1. 在震动的情况下，调低灵敏度。

1. reduce sensitivity in case of vibration.

2. 更换新电池或充电后再使用

2. replace the new battery or use it after charging

注：此时调低调低灵敏度不影响探测精度。

Note: low profile and low sensitivity do not affect the detection accuracy.

现象三：

Phenomenon three:

故障现象：开机红灯长亮，也不报警，也不振动

Fault phenomenon: red light on the start, no alarm, no vibration

原因分析： 出现此类现象，一般为探测器停用了一段时间，忘了取出电池，电池长期缓慢放电所至。

Reason analysis: this phenomenon occurs, usually for the detector stopped for a period of time, forget to take out the battery, the battery long-term slow discharge to.

排除方法：

Elimination method:

1. 只要更换新电池即可。

1. just replace the battery.

2. 注意电池盒是否被电池漏液污染，如污染的要及时清洗，否则会使电池扣或电路板腐蚀损坏。

2. pay attention to whether the battery box is contaminated by the battery leakage, such as pollution should be cleaned in time, otherwise it will cause damage to the battery button or circuit board.

3. 可用纯酒精清洗或专用电子清洗剂清洗。

3. can be cleaned by pure alcohol cleaning or special electronic cleaning agent.