| 手持金属器如何检查和维修 |
| 添加时间：2019/12/7 13:38:37 浏览次数： |
| 手持金属探测器一般做工比较简单，很容易损坏，那么手持金属器如何检查和维修呢？ The hand-held metal detector is generally simple and easy to be damaged, so how to check and repair the hand-held metal detector? 第一步首先要确认金属器的损坏部位，具体问题具体分析，在使用的过程中，手持金属探测器一些排除故障的方法。 The first step is to confirm the damaged parts of the metal device, analyze the specific problems, and in the process of use, some troubleshooting methods of hand-held metal detector. 故障1：开机红灯长亮，也不报警，也不振动 Fault 1: the red light is on for a long time, and there is no alarm or vibration 维修方法：出现此类现象，一般为探测器停用了一段时间，忘了取出电池，电池长期缓慢放电所至。 Maintenance method: this kind of phenomenon occurs when the detector is out of service for a period of time, forgetting to take out the battery, and the battery discharges slowly for a long time. 故障2：开机后探测任何东西都报警或轻微晃动也报警。 Fault 2: alarm when detecting anything after power on or alarm when shaking slightly. 维修方法：一般是因为将灵敏度调的过高，或在调高灵敏度探测细小金属后，没有及时调到原来正常位置所至，需要调低灵敏度。 Maintenance method: generally, it is because the sensitivity is adjusted too high, or after the sensitivity is adjusted to detect small metal, it is not adjusted to the original normal position in time, so the sensitivity needs to be adjusted low. 故障3：带震动的探测器，有时蜂鸣器工作正常，而转到震动时出现震动马达不能停下来。 Fault 3: with vibration detector, sometimes the buzzer works normally, but when turning to vibration, the vibration motor cannot stop. 维修方法：更换电池，需要满点的电池器，和降低灵敏度。 Maintenance method: replace the battery, need full battery, and reduce the sensitivity. |
| 上一页 食品金属检测机根据需要都采用两种不同的方式安装使用 |
| 下一页 怎样正确的调节地下金属探测器的临界声？ |
Copyright © 技术支持：遨游网络